4 answers

★ Best answer

Mid-drive motors pull massive current on steep hills, and if your controller is hitting its amp limit before the motor even gets hot, you'll lose assist mid-climb even with battery charge to spare. Try shifting to an easier gear before you hit the steep section - this sounds obvious but most people wait until they're already struggling, and by then the controller's already throttled back! If dropping gears earlier doesn't help, your motor controller might be aging or the phase wires between motor and battery could have a loose connection that increases resistance. Worth checking those connectors for corrosion since you've had it a year and it used to handle hills fine.

check if your motor's hitting a temperature cutoff - mid-drive motors throttle back when they get too hot, and sustained climbing under load is basically the worst case scenario for heat buildup. the battery showing charge doesn't matter if the controller decides the motor's in danger, so feel the motor housing after it cuts out; if it's scorching hot then that's your culprit and you might need better ventilation, a firmware update, or in worst case the motor's aging out. if it's not burning up, could be a current limit kicking in (some controllers have a thermal amp limit that triggers before physical temp does), but temperature is by far the most common reason mid-drives bail on steep hills.

Don't assume it's just heat - mid-drive motors have current limits and power cutoffs, so sustained steep climbing can trigger thermal throttling, but it can also be the motor controller limiting amperage to protect itself or the battery hitting a discharge rate ceiling. Temperature is definitely part of it (those motors really struggle on long climbs), but it's worth checking your battery voltage under load with a multimeter to see if it's sagging too much, or trying a shallower route to confirm the motor works fine on gentler grades - that'll tell you if it's a temperature issue versus the system hitting its electrical limits.

Your mid-drive is probably hitting either a thermal limit or an amp limit - and the tricky part is that both can happen independently of battery charge. The motor controller doesn't care how many watts the battery *could* provide; it's designed to protect itself by cutting out when either the motor temperature spikes or the current draw gets too high. On steep climbs, you're usually hammering both at once.

Here's what folks often miss: a throttle cutoff doesn't always *feel* like overheating. Your motor might be cutting assistance because the controller detected high current draw, not because you can feel heat coming off anything. Sustained steep climbing with a mid-drive forces the motor to work at max torque, which draws serious amps through a narrow thermal window. If your controller's amp limit kicks in before actual motor temperature becomes a problem, you'll get that mid-climb dropout even though everything feels cool.

The diagnostic move is to try the same hill at a lower assist level or by pedaling more actively to spread the load over time. If you can make it up on eco mode without cutting out, that's your answer - you're hitting the amp limit. If it cuts even on lower assist, or if the motor gets noticeably hot to the touch, temperature throttling is your culprit. You might also check whether your motor's firmware can be updated; some manufacturers have adjusted their thermal strategies after release. If neither of those works, the controller itself could be failing, but temperature and amperage limits are way more common.

Your answer

Log into answer.