Did you clean and sand the plastic surface beforehand?
that's usually the problem - plastic is just too smooth and the paint doesn't adhere properly. you should roughen up your models with fine sandpaper (like 400 grit or finer) so the paint has something to "grip" onto. after that wipe everything down thoroughly with water or a slightly damp cloth to get rid of the dust.
then you really need a primer - it's not optional, it's necessary. special plastic primers (or airbrush primer) stick way better to plastic than regular paint. if your Revell paint is too thick, you need to thin it with the right thinner (not just water, that doesn't work with every paint). the consistency should be like thin milk - if you hold it up to the light, you should still be able to see through it a bit. multiple thin coats are better than one thick one, otherwise you get splotches or it runs.
also pay attention to your air pressure and spray distance - if the pressure's too low or you're too far away, it comes out in little flecks instead of a fine mist. maybe try messing around with a test model until you get it right.