What could be wrong with my Orbis gas heater that stopped working?

Rodrigo Ribeiro BR 🔍 Enthusiast 👁 132 ⚑ Report Heating

I have an Orbis heater since 2009 that stopped turning on out of nowhere. I light the pilot, but the main flame won't come out. I've already cleaned the outlet opening, but nothing. Does anyone know if this is just a maintenance thing or if I should've replaced it a long time ago?

5 answers

★ Best answer

This problem is usually in the gas valve or the thermocouple. If the pilot lights but the main flame won't come on, it could be a clog in the gas line or the valve stuck (dirty even after you clean the outlet). With an appliance that old, it's also pretty common for the thermocouple to be too weak to keep the valve open. Get a technician to come clean or replace those parts, it's not expensive and fixes it most of the time.

When the pilot lights but the main flame won't ignite, nine times out of ten it's the thermocouple or a stuck solenoid valve. Since you've cleaned the burner, the next step is to check if the thermocouple is actually making contact with the pilot flame - sometimes it shifts slightly over time and the valve doesn't get the signal. Try moving it carefully, making sure it sits right under the flame.

If that's not it, the valve itself might be clogged with limescale deposits (especially if you have hard water). The trick nobody mentions is to turn everything off, wait 20 minutes, then turn it back on several times in a row - sometimes that forces the internal mechanism to come loose. If you're still out of luck, that solenoid valve probably needs to be replaced. At 15 years of use, some wear is normal; you don't need to swap out the whole heater, but that part has a limited lifespan.

Does the pilot light ignite normally and stay lit, or does it go out right away? Because yeah, if the thermocouple is dirty or the solenoid valve is stuck, that's true, but there's something the previous answers didn't mention: if your heater is 17 years old, the problem might just be plain wear and tear on the main gas valve, which gets stiffer over time. Before you call a technician, try tapping lightly - and I mean *lightly* - on the side of the valve with a wrench handle. Sometimes that unsticks it. If that doesn't work, you need to call a pro because messing with it too much can mess up the safety regulation.

Rodrigo Ribeiro asker The pilot keeps the flame, yeah, it just won't fire up the main burner. I'll try giving the valve a light tap, thanks!

I had a similar situation with an old heater and what nobody mentions is that if the pilot holds but the main valve won't open, it could also be low pressure in the gas circuit - like, the cylinder is weak or there's a tiny leak in the piping that goes unnoticed. Before calling someone, try checking if other gas flames in the house work normally; if everything else is fine, it's almost certain it's the thermocouple or the solenoid valve, and then it's worth taking it to a technician because that's not a DIY job.

With a heater that's been around this long, you're pretty much at the end of the line anyway, but before you call a technician there's one thing people don't really talk about: if the pilot lights normally and holds the flame, but the main burner won't open, it could just be dirt buildup on the needle that controls the gas flow (it's near the solenoid valve). I had a similar problem at home and the technician just cleaned that little needle, and everything worked again. If the pilot goes out right after you light it, though, that's when the thermocouple is weak and there's no way around it - you've gotta replace it.

Your answer

Log into answer.